-
For modern carbon target arrows, a high-quality epoxy is generally considered the
most reliable option for long-term durability and consistency. -
Hot-melt like the Bohning Ferr-L-Tite Cool Flex is advised for points and inserts
that may need to be removed or adjusted at a later moment. Please note not to apply
heat directly to the shaft. Excessive heat can damage carbon shafts and weaken the
bond between the carbon fibers and resin.
Installing with Hot Melt
-
Clean the Shaft
Remove all dust, grease, and debris from the inside of the shaft.
A clean bonding surface ensures the strongest hold.
-
Heat the Point or Insert
Use a small torch, lighter, or alcohol burner.
Heat the point or insert, not the carbon shaft.
The component only needs to be warm enough to melt the adhesive.
-
Apply the Hot Melt
Rub the hot melt stick against the heated insert or point until a thin, even
layer is applied.Avoid applying excessive adhesive.
-
Install the Component
Insert the point or insert into the shaft while slowly twisting.
Twisting helps spread the adhesive evenly throughout the bonding surface.
-
Align and Remove Excess Adhesive
Immediately wipe off any excess adhesive that squeezes out.
Check that the component is fully seated.
-
Check Alignment
Before the adhesive completely cools or dries, spin the arrow on an arrow
spinner.If necessary, make small corrections while the adhesive is still warm.
-
Allow to Cool
Let the arrow cool for several minutes before handling or shooting.
Using Glue for Points and Inserts
-
Clean the Components
Clean the inside of the shaft and the insert or point with isopropyl
alcohol.Remove all dust, grease, and residue.
Allow the components to dry completely.
-
Apply the Adhesive
Apply a thin, even layer of adhesive around the insert or point shank.
Avoid using excessive glue, as this can create air pockets and unnecessary
weight variation. -
Install the Component
Slowly insert the component while rotating it.
Twisting helps distribute the adhesive evenly across the entire bonding
surface. -
Fully Seat the Insert or Point
Push the component in until it is completely seated against the shaft.
Ensure there are no visible gaps.
-
Remove Excess Adhesive
Wipe away any excess glue immediately using a cloth or paper towel.
This creates a clean finish and prevents hardened residue around the shaft.
-
Check Alignment
Before the adhesive cures, spin the arrow on an arrow spinner.
Verify that the point runs true and does not wobble.
-
Allow the Adhesive to Cure
Follow the adhesive manufacturer’s recommended curing time.
Do not shoot the arrows until the adhesive has fully cured.